Fleximent® 201

What is Fleximent® 201

Fleximent® 201 is a two-component, flexible cementitious waterproof coating comprising of a proprietary synthetic resin dispersion and a blend of selected cement mixed with fillers.

MAKE AN ENQUIRY BROCHURES SPECS CERTS
  • Toilets, kitchens, pantries, refuse collection points and M&E rooms etc.
  • Wet areas such as swimming pools, water features, ponds etc.
  • Floors, walls, water retaining structures and planter boxes
  • Flexible cementitious coating
  • Adheres to most surfaces
  • Fills hairline cracks
  • Excellent resistance to wear, weather, abrasion
  • Effective waterproof coating for floors, walls, water retaining structures and planter boxes
  • Allows entrapped water vapour to escape but remains impermeable to water
  • Protects against aggressive soils and contaminated ground water
  • Can be applied onto surfaces in contact with potable water and damp surfaces
  • Contains no chlorine and salts that cause corrosion and efflorescence
  • Resistant to frost and thawing salts
  • Non-polluting of drinking water
  • Meets BS 6920:90 and SS 375:94 requirements
  • Green label
  • Can be applied on damp surfaces
  • Excellent durability reduces future maintenance costs
  • Compatible with drinking water

Surface Preparation
The substrates must be wood trowelled smooth, clean and sound, free of dust, loose particles. Cement laitance, oil grease mould release oil or curing compounds must be removed from concrete surfaces by using wire brush, brush hammer, scabbler, grit blasting or other means.

All substrates must be dampened with water prior to application of Fleximent® 201.

Material Mixing
Pour Part A (liquid) into a clean container and stir/mix with a low speed drill fitted with a purpose made paddle. Pour Part B (powder) slowly into Part A taking care to mix thoroughly until homogeneous and lump-free.

Application
For horizontal and vertical surfaces, a squeegee, roller or broad brush may be used to apply the slurry. Care must be taken to ensure that air is not entrapped in the membrane.

Apply with brush to joints and corners ensuring that areas are worked well into and allow curing to set for approximately an hour (depending on concrete substrate) before application of second coat.

General floor area application is approximately 1.2 mm thick, applied in two coats.

Curing and Protection
Normal concreting procedures should be strictly adhered to. For horizontal areas where the membrane may be subjected to heavy abrasion or tearing, the membrane should be protected with a screed topping.

PROPERTYVALUETEST METHOD
Mix density1300 kg/m³-
Mixed colourGrey
Pot life @ 35°CApprox. 1 h
Drying time1 – 3 h
Tensile strength>1.6 N/mm²ASTM D412
Elongation at break>150 %ASTM D412
Water vapour transmission21 g/m² · dayASTM E96
Water penetration test0DIN 104
Crack bridging ability2 mmASTM C836
Shore A hardness>50ASTM D2240
Adhesion to concrete>1.0 N/mm²ASTM D4541